Lead Armort Bug

Discussion in 'Support' started by Yagudo, Jun 7, 2016.

  1. Yagudo

    Yagudo Member

    Joined:
    May 22, 2016
    Messages:
    28
    Likes Received:
    0
    bug report for my problem ... my problem is i created a space station in the overworld save the schematic with worldedit to a file ..
    put the schematic in the orbit sealed a room and wear the fully lead armor... but she pushed me up..

    see the following Picture:
    [​IMG]
    in this first picture you see i wear the lead armor and stand on the floor.. the room is sealed

    [​IMG]

    The secound picture is take a few secounds later you see i wear the armor but i hangs in the air....

    Now this pictures was taken on a mars station in the mars orbit
    [​IMG]

    I wear the armor to the room is sealed i jump and falls down to the floor... it works but why not in the main station at the two pictures below ?

    Or it may be because I have built the space station on the Overworld which I have saved as a schematic but this includes the air blocks the Overworld? and thus there are conflicts?

    I have therefore not built in all because it's very difficult to move Now it stands and the armor pushes me upwards ...
    on a new station in Mars orbit does the armor ..
    Just not on the station which has been recorded as a schematic

    sry for my english, I'm from Germany.
    i hope you can understand me
    where is the fix
     
  2. Yagudo

    Yagudo Member

    Joined:
    May 22, 2016
    Messages:
    28
    Likes Received:
    0
    #2 Yagudo, Jun 7, 2016
    Last edited: Jun 10, 2016
  3. Yagudo

    Yagudo Member

    Joined:
    May 22, 2016
    Messages:
    28
    Likes Received:
    0
    PLEASE HELP!
     

Share This Page